Then when you follow the manufacturer's procedure to pair again (which could be the wireless key pad first OR the remote first), the first pairing determines the technology for all subsequent pairings. 6 seconds or more), you erase all codes and remote "pairings". When you reset all codes (normally by pressing a button on the opener for a period of time e.g. I had the same issue recently and here's what I found out (through a LOT of research) and the solution (yes, there is one!):Īs described by many, when you can't get both the remote and the wireless pad to work together it means your garage door opener can accept both rolling code and billing code technology, BUT not at the same time. I have verified that all of the wires are properly connected on the back of the keypad as well. All I know is that I got the code roaming one and I got the one that had the wireless outside keypad as well as the "fully loaded" indoor hard wired key pad with the motion sensor.Īny info would be greatly appreciated. It's probably the most common garage door opener on the planet, but I'll dig for the model number when I get home. I don't have the model number right here with me, but it's the million code hopping kind, not the 300mhz one, it's before that. I don't know what that means but that's all I can make of it. I also noticed that the yellow light above the learn button on the main unit, it is constantly flashing what looks to me like a code. you can still disable the remotes and re-enable them with the lock button, you just can't tell which mode you are in because the light is flashing already anyway. The light button on the keypad still works and although you don't get a confirmation because the light is already flashing VERY fast, vacation mode still works. All of the remotes still work, the outside wireless keypad works still, just not the button itself. On this wall unit, the green light flashes MUCH faster than vacation mode, you can not get it to stop no matter what you do, I've tried holding the lock for a full minute, I've power cycled the garage door unit, it still happens. On my hard wired keypad, I have the pad that has the motion sensor for the light, a lock button, a light button, and of course the big door open button with the green light in it. The light flashes MUCH faster than that and no matter what you do, it won't go away and the hard wired button on the wall does NOT work. You enable and disable this mode by holding the lock button for 3 seconds. When the garage door opener is in vacation mode, you get a constant quick blink of the light. The remotes work fine, the external wireless keypad all work fine, but the button on the wall unit doesn't. It's a 1/2HP craftsman door opener from 1999 that's been working just fine up until this week. my name is Don as well and I too am having the same exact issue.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |